Owner's manual

LUBRICATION GUIDE
Check and lubricate all components at the intervals outlined in the Periodic
Maintenance Chart. Items not listed in the chart should be lubricated at the
General Lubrication interval.
The a-arms and upper control arms are lubricated at the factory, and no
additional lubrication will be needed. However, if these components are
subjected to severe use, grease zerks have been provided for additional
lubrication at the user's discretion.
ITEM SUGGESTED
LUBRICANT
CAPACITY AT
FLUID
CHANGE
FILL PLUG
TORQUE
DRAIN PLUG
TORQUE
REF.
Engine Oil
PS-4 5W-50 4-
Cycle Oil
1.9 l
(2 qt.)
–
19-23 Nm
(14-17 ft-lbs)
page
116
Brake Fluid
DOT 4 Brake
Fluid
– – –
page
126
Transmis-
sion Oil
AGL Gearcase
Lubricant &
Transmission
Fluid
946 ml
(32 oz.)
27-34 Nm
(20-25 ft-lbs)
27-34 Nm
(20-25 ft-lbs)
page
121
Demand
Drive Fluid
(Front
Gearcase)
Demand Drive
Fluid
275 ml
(9.3 oz.)
11–14 Nm
(8–10 ft-lbs)
15 Nm
(11 ft-lbs)
page
122
Rear
Gearcase
Oil
ATV Angle
Drive Fluid (or
GL5 80–90
weight gear
lube)
210 ml
(7.1 oz.)
14–19 Nm
(10–14 ft-lbs)
14–19 Nm
(10–14 ft-lbs)
page
122
Front Prop
Shaft Yoke
U-Joint Grease
Grease fitting (3 pumps maximum) every 800 km (500 miles),
before long periods of storage, or after pressure washing or
submerging.
ENGINE OIL
Always check and change the oil at the intervals outlined in the Periodic
Maintenance Chart. Always use the recommended engine oil. Always change
the oil filter whenever changing oil.
Pay special attention to the oil level. A rise in oil level during cold weather can
indicate contaminants collecting in the oil sump or crankcase. Change oil
immediately if the oil level begins to rise. Monitor the oil level, and if it continues
to rise, discontinue use and determine the cause. Your dealer can assist.
116
MAINTENANCE