Service Manual

10.4
ELECTRICAL
SWITCHES / CONTROLS
Headlamp Switch
1. Disconnect the headlamp switch harness (Brown, Green,
and Red/Yellow), by depressing the connector lock and
pulling on the connector. Do not pull on the wiring.
2. Test the switch connections and check for continuity at the
following pins as shown in the illustration.
AWD Switch
1. Disconnect the switch harness (Grey, Red/White, and
Brown), by depressing the connector lock and pulling on
the connector. Do not pull on the wiring.
2. Test the switch connections and check for continuity at the
pins shown in the illustration.
Brake Light Switch
1. The brake light switch is located under the driver’s seat
along the lower frame. The brake pressure switch is
installed into this cross fitting block.
2. Disconnect wire harness from switch.
3. Connect an ohmmeter across switch contacts. Reading
should be infinite (•).
4. Apply foot brake and check for continuity between switch
contacts. If there is no continuity or greater than .5 ohms
resistance when the brake is applied with slight pressure,
first clean the switch contacts and re-test. Replace switch
if necessary.
12345678
ON X X X
OFF
SWITCH
BACK
LIGHT
XX
HEADLAMP SWITCH
BACK VIEW OF SWITCH
12345678
ON X X X
OFF
SWITCH
BACK
LIGHT
XX
AWD SWITCH
BACK VIEW OF SWITCH