Service Manual
Table Of Contents
- 2008 RANGER RZR SERVICE MANUAL
- GENERAL INFORMATION
- MAINTENANCE
- PERIODIC MAINTENANCE CHART
- COMPONENT INSPECTION / SERVICE LOCATIONS
- LUBRICANTS / SERVICE PRODUCTS
- MAINTENANCE REFERENCES
- GENERAL VEHICLE INSPECTION AND MAINTENANCE
- FUEL SYSTEM AND AIR INTAKE
- ENGINE
- TRANSMISSION AND GEARCASES
- COOLING SYSTEM
- FINAL DRIVE / WHEEL AND TIRE
- ELECTRICAL AND IGNITION SYSTEM
- STEERING AND SUSPENSION
- BRAKE SYSTEM
- ENGINE
- ENGINE SPECIFICATIONS
- ENGINE COOLING SYSTEM
- GENERAL ENGINE SERVICE
- ENGINE DISASSEMBLY AND INSPECTION
- Cylinder Head Assembly Exploded View
- Rocker Arms
- Push Rods
- Cylinder Head Removal
- Cylinder Head Inspection
- Cylinder Head Warp
- Valve Seal / Spring Service (On Engine)
- Cylinder Head Disassembly
- Valve Inspection
- Combustion Chamber
- Valve Seat Reconditioning
- Cylinder Head Reassembly
- Valve Sealing Test
- Cylinder Removal
- Valve Lifter Removal / Inspection
- Piston Removal
- Cylinder Inspection
- Cylinder Hone Selection and Honing Procedure
- Honing To Deglaze
- Cleaning the Cylinder After Honing
- Piston-to-Cylinder Clearance
- Piston / Rod Inspection
- Piston Ring Installed Gap
- Starter Drive Bendix Removal / Inspection
- Flywheel / Stator Removal / Inspection
- Engine Crankcase Disassembly / Inspection
- Camshaft Inspection
- ENGINE REASSEMBLY
- ENGINE INSTALLATION
- TROUBLESHOOTING
- ELECTRONIC FUEL INJECTION
- GENERAL INFORMATION
- FUEL TANK
- ELECTRONIC FUEL INJECTION
- ELECTRONIC CONTROL UNIT (ECU)
- TEMPERATURE AND BAROMETRIC AIR PRESSURE SENSOR (T-BAP)
- CRANKSHAFT POSITION SENSOR (CPS)
- FUEL INJECTORS
- FUEL PUMP
- FUEL PRESSURE REGULATOR
- THROTTLE POSITION SENSOR (TPS)
- ENGINE COOLANT TEMPERATURE SENSOR (ECT)
- IGNITION COIL
- GENERAL TROUBLESHOOTING
- EFI SYSTEM BREAKOUT DIAGRAMS
- Diagnostic Connector Circuit
- Malfunction Indicator Lamp (MIL) Circuit
- Fuel Injector (PTO) Circuit
- Fuel Injector (MAG) Circuit
- Engine Coolant Temperature Sensor (ECT) Circuit
- Engine Overheat Lamp Driver Circuit
- Crankshaft Position Sensor (CPS) Circuit
- Air Temperature and Barometric Air Pressure Sensor (T-BAP) Circuit
- Throttle Position Sensor (TPS) Circuit
- Fuel Pump Circuit
- BODY / STEERING / SUSPENSION
- CLUTCHING
- FINAL DRIVE
- TRANSMISSION
- BRAKES
- GENERAL SPECIFICATIONS
- TORQUE SPECIFICATIONS
- SPECIAL TOOLS
- BRAKE SYSTEM SERVICE NOTES
- BRAKE NOISE TROUBLESHOOTING
- HYDRAULIC BRAKE SYSTEM OPERATION
- BRAKE SYSTEM EXPLODED VIEW
- MASTER CYLINDER
- BRAKE PEDAL LEVER
- BRAKE BLEEDING / FLUID CHANGE
- FRONT BRAKE PADS
- FRONT CALIPER SERVICE
- FRONT BRAKE DISC
- REAR BRAKE PAD
- REAR CALIPER SERVICE
- REAR BRAKE DISC
- TROUBLESHOOTING
- ELECTRICAL
- General Information
- Switches / Controls
- Instrument Cluster
- Instrument Cluster Troubleshooting Tests
- All Wheel Drive Coil
- Gear Position Indicator Switch
- Speed Sensor
- Head Lights
- Tail / Brake / Work Lights
- Cooling System Schematic
- EFI Diagnostics
- Fuel Sender
- Relays
- Fuse Box Layout
- Fuses / Circuit Breaker
- Charging System
- Battery Service
- Conventional Battery
- Low Maintenance Battery
- Starting System
- Starting System Testing Flow Chart
- Electrical BreakOut Diagrams
- INDEX
- WIRE DIAGRAMS
4.32
ELECTRONIC FUEL INJECTION
GENERAL TROUBLESHOOTING
Diagnostic “Blink Codes”
NOTE: The EFI diagnostic mode is intended to
quickly view the cause of the “Check Engine” light.
To recall blink codes (fail codes) from the ECU:
1. Verify the key switch is off and the transmission is in
neutral with the parking brake applied.
2. Turn the key switch ON and OFF 3 times within 5 seconds
and leave the key switch in the ON position on the third
turn. The word “Wait” will appear as the ECU searches for
blink codes.
3. Any “blink codes” stored in the ECU will display a
numerical “blink code”, one at a time, in numerical order,
on the instrument cluster display.
4. The word “End” and/or the number “61” will display after
all of the codes have been displayed or if no codes are
present.
NOTE: To clear codes manually, disconnect the
positive battery lead for 20 seconds.
DIAGNOSTIC “BLINK CODES” CHART
SAE CODE BLINK CODE NAME CHECK ENGINE
P0335 21 Loss of Synchronization Yes
P0122 22 TPS: Open or Short Circuit to Ground Yes
P0123 22 TPS: Short Circuit to Battery Yes
P0601 23 RAM Error: Defective ECU Yes
P0914 25 Transmission Input: Invalid Gear Yes
P0113 41 Intake Air Temp Sensor: Open or Short Circuit to +Sensor Voltage (ECU) Yes
P0112 41 Intake Air Temp Sensor: Short Circuit to Ground Yes
P0117 42 Engine Temperature Sensor Circuit: Short To Ground Yes
P0118 42 Engine Temperature Sensor Circuit: Open or Short to Battery Yes
P0107 45 Barometric Pressure Sensor: Circuit Low Input Yes
P0108 46 Barometric Pressure Sensor: Circuit High Input Yes
P1260 51 Injector 1: Open Load Yes
P0261 51 Injector 1: Short Circuit to Ground Yes
P0262 51 Injector 1: Short Circuit to Battery Yes
P1263 52 Injector 2: Open Load Yes
P0264 52 Injector 2: Short Circuit to Ground Yes
P0265 52 Injector 2: Short Circuit to Battery Yes
P0655 54 Engine Temperature Lamp: Open Load Yes
P1657 54 Engine Temperature Lamp: Short Circuit to Ground Yes
P1658 54 Engine Temperature Lamp: Short Circuit to Battery Yes
P1651 55 Diagnostic Lamp: Open Load Yes
P1652 55 Diagnostic Lamp: Short Circuit to Ground Yes
P1653 55 Diagnostic Lamp: Short Circuit To Battery Yes
P1231 56 Pump Relay: Open Load Yes
P1232 56 Pump Relay: Short Circuit to Ground Yes
P1233 56 Pump Relay: Short Circuit to Battery Yes