Owner's manual

5. Reinstall the harness assembly into the headlight assembly.

HEADLIGHT BEAM ADJUSTMENT

To adjust the headlight beam, do the following:

1. Place the vehicle on a level surface with the headlight approximately 25 ft.

(7.6 m) from a wall.

2. Measure the distance from the floor to the center of the headlight and make a

mark on the wall at the same height.

3. Apply the brakes. Start the engine. Turn on the headlights.

4. Observe the headlight aim. The most intense part of the headlight beam

should be aimed 8" (20 cm) below the mark placed on the wall. Include the

weight of a rider on the seat while performing this step.

5. If a headlight needs adjustment, locate the adjustment screw at the back of

the headlight.

6. Loosen the screw, adjust the headlight, and tighten the screw.

7. Repeat steps 4-6 until the lamp is properly adjusted.

MAINTENANCE