Owner's manual

CAUTION
Always remove all cargo from the cargo box before lifting the box to access
engine components.
CAUTION
Hot oil can cause burns to skin. Do not allow hot oil to contact skin.
Access the oil fill cap, dipstick and filter under the cargo box.
1. Remove all cargo from the cargo box.
2. Position the vehicle on a level surface.
3. Place the transmission in PARK.
4. Stand clear and pull up on the cargo box release lever. Lift the front of the
cargo box.
5. Locate the crankcase drain plug access hole in the skid plate.
6. Clean the area around the crankcase drain plug.
7. Place a drain pan under the engine crankcase and remove the drain plug.
Allow the oil to drain completely.
8. Using an oil filter wrench, turn the filter counterclockwise to remove it.
9. Using a clean dry cloth, clean the filter sealing surface on the crankcase.
10. Lubricate the o-ring on the new filter with a film of fresh engine oil. Check to
make sure the o-ring is in good condition.
11. Install the new filter and turn by hand until the filter gasket contacts the
sealing surface, then turn an additional 3/4 turn.
12. Reinstall the drain plug. Torque the drain plug to 12 ft-lbs (16 Nm).
13. Remove the oil fill cap and add 2.5 quarts (2.4 l) of recommended oil.
Reinstall the fill cap.
14. Start the engine and check for leaks.
15. Stop the engine and wait 15 seconds before removing the dipstick.
16. Remove the dipstick. Wipe it dry with a clean cloth.
17. Reinstall the dipstick completely. Remove the dipstick and check the oil
level.
18. Remove the oil fill cap and add oil as needed to bring the level to the upper
mark on the dipstick. Do not overfill.
19. Reinstall the fill cap. Reinstall the dipstick.
20. Lower the cargo box and push down securely to latch.
21. Dispose of used filter and oil properly.
87
MAINTENANCE