2005 ATV Owner's Manual

145
ADJUSTMENTS
Chain Ten sio n
Check the amount of chain slack by moving the vehicle slightly forward to remove slack at
the top side of the chain.
NOTE: The chain has a press-on master link. A chain tool must be used if it’s necessary
to remove the chain for service.
1. Collapse the suspension with an adjustable (buckle type) t railer tie down strap (A).
Fasten the strap around the axle and rear bumper tube.
2. Tighten the strap until a straight line (B) can be drawn from the axle to the t ransmission
output shaft, intersecting the swing arm pivot. This establishes the tightest chain
position.
3. At this point (C) the chain should have 1/4″ -3/8″ (.6 -.9 cm) deflection. Use the
procedure on the following page if the chain needs adjustment.