Owner's Manual

AdjustSweepHosetoFitPoolDepth
1. Measurethedeepestpartofthepool.
Addtwofeettothismeasurementtodetermine
thecorrectlengthforthe
sweephose.
2. Ifthesweephoseislongerthan
themeasuredamount,cutoffthe
excesshose.
3. Removethehoseconnectorfromtheexcess
hosepiecejustcut.
4. Usefingerstocollapsesweephose.Pushhose
intoconnectoruntilthefirstgrooveisinside.
5. Slidefingersinsidehose,throughconnector,
andpophosebackto
originalshape.
AdjustFloatHosetoFitPool
Length
Withfloathoseattachedtothepoolwallatthereturnline,extendthehosetothefarthestpointofthepool.The
endofthehoseshouldbe4feetshorterthanthispoint.
Hosetoolong?Cuttheexcessfloathose.Removethehoseconnectorfromtheexcesshosepieceand
attachittothenewendofthefloathoseasinstructedabove.
Hosetooshort? For Polaris165/SuperTurtleonly,addthefloathoseextensionbetweenthe
existingfloathosesectionandthesurfacemodule.Remeasureandadjustasnecessary.
1. Opentheframeoffilterbagcompletelyandattachittojetsweepassembly.Attachassemblytosweep
hose.
2. Attachfloathoseandsweephosetothesurfacemodule.
3. PutthePolarisinthepoolandturnonthepoolfiltrationpump.
4. Extendthefloathosetothefarthestpointinthepool.Whenthepoolpumpisrunning,thesurface
moduleshouldbeapproximatelyonefootfromthepoolwall.
www.polarispool.com
English
4 Feet
Return line
Return line
4 feet
2
Collapse Here
Insert
to Here
Hose
Connector
3