Owner's Manual



 
The control unit will display one of ten different error codes to indicate specic problems with either the control unit or
mechanically with the cleaner.
• To remove an error code after troubleshooting, press any key and the control box turns off.
• If an error code is displayed and no key pressed, the screen goes into standby mode after 10 minutes of inactivity.
Press any key to turn the screen back on.
• When an error is detected, programming for the control unit is temporarily suspended. The button is
turned off.
Press and hold the
button to clear the error code and reactivate current programming.
  

 

 


 








 

 
Additional information about your cleaner's current status and any relevent error condition is available
through a troubleshooting status screen. To view this information:
1. Remove cleaner from the pool and turn power off.
2. Press and at the same time and hold for at least ve (5) seconds.
The following cleaner operation messages are displayed consecutively for three (3) seconds:



After cycling through each message, control unit returns to current day and time display.