Owner's Manual
2. Separate the edges of the brush and undo the
tabs (Figure 27). Remove the worn brushes.
2
3. To install a new brush, position the new brush
on the roller with the spikes facing downwards
(Figure 28).
3
4. Thread each tab into the slot provided and
gently feed it through until the heel comes out
at the other side of the slot (Figure 29).
4
5. Use a pair of scissors to cut the tabs 3/4 inch
from the heel so that they are no higher than the
spikes (Figure 30).
7
The cleaner is tted with PVC brushes. There are ''wear''
indicators on the brushes (Figure 25). To maintain
cleaner performance at its best you need to replace the
brushes as soon as one of the wear indicators is reached
(even if the blade wear is not even). It is recommended
that you replace the brushes when the wear indicator is
reach or every two (2) years which ever comes rst.
1. Lift the cleaner to a vertical position so that the
handle is up (Figure 26).
1