Owner's Manual
The lter canister should be cleaned at the end of each
cycle.
1. Make sure the control unit cable is
disconnected from the electrical outlet or the
oating cable has been disconnected from the
control unit.
2. Remove the cleaner from the water and let
the remaining water drain by maintaining the
cleaner in the vertical position.
3. Set the unit on its wheels.
4. To remove the lter from the cleaner, follow
steps 5 through 8.
5. Push the cover lock (1) and lift the cover (2)
until it is secured in the vertical position.
(Figure 20).
2
1
6. Remove the lter assembly from the body (3),
as shown in Figure 21.
3
7. Push the quick release button on the canister
assembly (4) and pull open the lter assembly
(5). (See Figure 22.)
4
5
8. Separate the lter canister from the lter
support (6). (See Figure 23.)
6
9. Empty all debris from the lter canister, then
rinse the canister, the lter support, and the
cleaner under water or using a hose
(Figure 24).