Owner's Manual





You can program up to three (3) preset cleaning cycles
to run the cleaner on a specic day and time when you
are away from the pool


 
Press to display current day and time.

 
1. Press and hold for three (3) seconds.

2. Press or buttons to cycle
through seven (7) days and display desired day.
3. Press
to select.

4. Press or buttons to cycle
through 24 hours and display desired hour
setting.
 

5. Press to select.

6. Press or buttons to cycle
through 1-59 minutes and display desired
minutes setting.
7. Press
to select.
The display ashes for you to begin
programming a cleaning cycle if necessary (see
section 5.3 Setting Cleaning Cycles).
8. Press
or to set displayed time
as current and exit the menu.
9. Press
to display current day and time
setting and verify the time you set is correct.
 
You can program up to seven cleaning cycles. After
completion of the seventh cycle, the PROG LED
turns off. You may program cleaning for either seven
consecutive cycles or the same cycle repeated over
several weeks (e.g., every Wednesday and Saturday for
three weeks).
1. Press
to select either bottom of
pool or bottom plus sides of pool.
2. Press
to view each of the currrent
programmed cleaning cycles. Cycle day and
time is displayed for three seconds.
3. When the cleaning cycle you want to change is
displayed, press and hold
.