Owner's Manual

Page 14
4. Thread each tab into the slot provided and gently
feed it through until the heel comes out at the
other side of the slot. Refer to Figure 34.
5. Use a pair of scissors to cut the tabs 3/4 inch from
the heel so that they are no higher than the spikes
as shown in Figure 35.
6. Repeat this procedure to install the second brush.
4
Figure 34. Pull Tabs Through Each Slot
Figure 35. Cut Tabs
5.4 Replacing the Tires on the Cleaner
1. Pull on the inside of the old tire to remove the tire
lip from the wheel. See Figure 36.
2. Remove the old tire as shown in Figure 37.
3. To replace the tire, position the tire on the wheel
making sure to orient the tire so that the tread is on
the outer side of the wheel. See Figure 38.
IMPORTANT NOTE The word "inside" is imprinted on
the rim of the tire. Make sure the
word "inside" is facing towards the
body of the cleaner.
1
2
Figure 36. Pull the Old Tire Over the Wheel
Figure 37. Remove the Old Tire
Figure 38. Tire Replacement Orientation
1
I
N
S
I
D
E
Towards
Body
I
N
S
I
D
E
I
N
S
I
D
E
English