Owner's Manual

Page 13

2. Separate the edges of the brush and undo the tabs

as shown is Figure 32. Remove the worn brushes.

Figure 31. Clean in Upright Position

3. To install a new brush, position the new brush on

the roller with the spikes facing downwards. Refer

to Figure 33.

Figure 32. Undo the Tabs of the Brush

Figure 33. Install the New Brush

5.3 Replacing the Brushes

The cleaner is ﬁ tted with PVC brushes. There are ''wear''

indicators on the brushes. To maintain cleaner perfor-

mance at its best you need to replace the brushes as soon

as one of the wear indicators has been reached (even if

the blade wear is not even). Zodiac Pool Systems, Inc.

recommends that you replace the brushes every two (2)

years.

1. Lift the cleaner to a vertical position so that the

handle is up. Refer to Figure 31.

5.2 Cleaning and Storing the Cleaner

The cleaner must be cleaned regularly using slightly

soapy clean water, do not use solvents such a trichloro-

ethylene or its equivalent. Rinse the cleaner generously

using clean water. Do not let your cleaner dry in direct

sunlight near the pool. The cleaner must be stored on its

own caddy, so that it dries quickly.

1. Place the rear wheels on the caddy side wedges as

shown in Figure 29.

Figure 29. Position Cleaner on Caddy

2. Roll the unit into place onto the caddy. Refer to

Figure 30.

NOTE The cleaner cable must be disconnected from

the control box before removing the cleaner

from the pool. Wrap the cleaner cable around

the hooks located at the rear of the caddy.

Figure 30. Roll Cleaner onto Place on the Caddy

English