Owner's Manual

Page 9
English
Section 5. Cleaning and
Maintenance
WARNING
To avoid electric shock and other hazards which
could result in permanent injury or death, disconnect
(unplug) the cleaner from the electrical outlet before
performing any cleaning and maintenance.
5.1 Cleaning the Filter Canister
The lter canister should be cleaned at the end of each
cycle.
1. Ensure that the control unit cable has been
disconnected from the electrical outlet.
2. Set the unit on its wheels.
3. Push the cover latch and lift the cover. Refer to
Figure 9.
Figure 9. Open Cover of the Cleaner
4. Remove the lter assembly from the body, as
shown in Figure 10.
Figure 10. Remove the Filter Canister/Cover
Assembly
5. Press the canister clip with your nger to
separate the lter canister from the top cover, as
shown in Figure 11.
6. Wash the lter canister with clean water from
a hose.
Figure 11. Remove Filter Canister from Cover
5.2 Replacing the Filter Canister
1. Position the lter canister hooks on the top
cover receiving pins, as shown in Figure 12.
Top Cover
Receiving Pins
Top Cover
Figure 12. Engaging the Filter Canister Hooks on
Top Cover
2. Rotate the lter canister and lock it in place
using the front clip. Refer to Figure 13. When
the lter canister is installed properly on the
top cover, it will be rmly attached.
3. Locate the top cover hinges under the body
shoulders, as shown in Figure 14.