Owner's manual

MAINTENANCE

Oil and Filter Change

Oil Pump Priming

This priming procedure must be

performed whenever the oil hose

connection between the oil tank and

pump inlet has been disconnected.

1. Clamp or pinch off the vent line

approximately 2" (5 cm) from the oil

tank, between the end of the oil tank

vent fitting and the vent line's

pressure relief slit.

2. Start the engine. Allow it to idle for

10-20 seconds.

3. Remove the vent line clamp. If the line is bled properly, you should

hear a rush of air, indicating that the line is properly primed and

ready for operation.

Tip: If you do not hear air, the line has not bled. Repeat the priming procedure.

Transmission Oil

Always check and change the transmission oil at the intervals outlined

in the Periodic Maintenance Chart beginning on page 72. Maintain the

oil level at the bottom of the fill plug hole threads. See page 125 for the

part numbers of POLARIS products.

The fill plug is located on the left side of the ATV, under the rear fender,

behind the wheel. The drain plug is located on the right side of the

gearcase, on the right side of the ATV, behind the wheel well.

Clamp

Pressure

Relief Slit

Tank

(5 cm)

Drain Plug

Fill Plug