Service Manual

3.27
ELECTRONIC FUEL INJECTION
3
Idle Speed
Speed Too High 520211 3
Speed Too Low 520211 4
Calibration Checksum/CRC Error 630 13
Steering Over Current Shut Down Current Above Normal or Grounded 520221 6
Steering Excessive Current Error Current Above Normal or Grounded 520222 6
Steering Torque or Speed Sensor
Partial Failure
Condition Exists 520223 31
Steering Torque or Speed Sensor
Full Failure
Condition Exists 520224 31
EPAS Inverter Temperature
Greater than 110° C (230° F) 520225 16
Greater than 120° C (248° F) 520225 0
EPAS CAN Communications
Receive Error
No RX Message for 2 Seconds 520226 2
EPAS CAN Communications
Transmit Error
No TX Message for 2 Seconds 520227 2
Vehicle Speed (This is applicable
when the EPAS module gets the
vehicle speed from the ECM)
Received Vehicle Speed Has Error 84 19
Engine Speed (This is applicable
when the EPAS module gets the
engine speed from the ECM)
Received Engine Speed Has Error 190 19
Battery Voltage
Too High 168 3
Too Low 168 4
Position Encoder Error 520228 11
EPAS Software Error
Software Error Illegal Memory Access 520229 12
Software Error Stack Overrun 520229 12
Software Error Illegal Peripheral
Interrupt
520229 12
IC CAN Communication with EPAS EPAS Off Line (EPAS DM1 not seen) 520230 31
EEProm: Read/Write Failure 628 12
DIAGNOSTIC TROUBLE CODE TABLE
Component Condition
SPN
Suspect Parameter Number
FMI
Failure Mode Indentifier