Service Manual

2.13
MAINTENANCE
2
NOTE: The sealing surfaces on the drain plug and
crankcase should be clean and free of burrs, nicks
or scratches.
9. Reinstall drain plug and torque to 12 ft. lbs. (16 Nm).
10. Locate oil filter through access hole in the skid plate. Place
shop towels beneath the oil filter. Using oil filter wrench
(PV-43527) turn oil filter counterclockwise to remove it.
11. Use a clean dry towel to clean the filter sealing surface on
the crankcase.
12. Check to make sure the O-ring on the new oil filter is in
good condition. Lubricate O-ring on new filter with a film
of fresh engine oil.
13. Install new oil filter and turn by hand until filter gasket
contacts the sealing surface, then turn it and additional 1/2
turn.
14. Remove dipstick and fill engine with 1.75 qts. (1.66 L) of
the recommended engine oil.
15. Start the engine and allow it to idle for one to two minutes.
16. Stop the engine and check for leaks.
17. Re-check the oil level on the dipstick and add oil as
necessary to bring the level to the upper mark on the
dipstick.
18. Dispose of used oil and filter properly.
Engine Breather Hose
Be sure engine breather hose is routed properly and secured in
place. CAUTION: Make sure line is not kinked or pinched.
Engine Breather Assembly
The engine breather assembly is located on top of the valve
cover. Inspect and service the breather components as required.
= T
Engine Drain Plug: 12 ft. lbs. (16 Nm)
= T
Oil Filter Torque:
Turn by hand until filter gasket contacts sealing
surface, then turn an additional 1/2 turn.
=
Recommended Engine Oil:
PS-4 PLUS Synthetic 4-Cycle Engine Oil
(PN 2876244) (Quart)
Inspect
Breather
Airbox