Service Manual

7.6
CLUTCHING (PVT)
Disassembly
Some fasteners and procedures will vary. Refer to the
appropriate parts manual for proper fastener placement.
1. Remove the left rear wheel and lower left-hand frame
support (see “DRIVE BELT - Belt Removal”, steps 1-4).
2. Remove the (10) push rivets and (4) Torx-headed screws
retaining the rear cab assembly.
3. Remove the tail light bulbs from the tail lamps, disconnect
the tail light harnesses from the rear cab, and remove the
rear cab to allow access to the PVT system for disassembly.
4. Remove the (11) screws retaining the outer PVT cover.
5. Using care, pull the outer PVT cover out the left-hand
wheel well.
6. Mark the drive belt direction of rotation and remove drive
belt (see “DRIVE BELT - Belt Removal”, steps 8-10).
7. Loosen the clamps and remove the PVT outlet duct from
the inner PVT cover.
8. Rotate and remove the PVT outlet duct from the vehicle to
allow for driven clutch removal.
9. Remove the driven clutch retaining bolt and driven clutch.