Service Manual

5.42
ENGINE
6. Measure pump rotor clearance to pump cover plate with a
feeler gauge through the pump outlet window and compare
to specification.
7. Measure shaft axial (end) free play and compare to
specification.
8. Inspect inner rotor drive pin for wear or damage.
9. Remove oil pressure relief from crankcase. Replace if
debris has entered, or if oil pressure was outside of specified
range.
= T
20 ± 2 ft. lbs. (27 ± 3 Nm)
OIL PUMP DETAIL
6-8 lb-in. (.69-.89 Nm)
M3 end cap screws
Gear must turn freely
after assembly