Offroad Vehicle User Manual

MAINTENANCE AND LUBRICATION

Adjustments

Rear Axle Drive Chain Adjustment

To adjust the rear axle drive chain, loosen the rearmost eccentric

locking bolts and rotate using the s ame m ethod as outlined for t he front

chain adjustment. Total slack for the rear chain should be adjusted to

3/8″-1/2″ (.95-.1. 3 cm) at the tightest point in the chain.

Carburetor/Engine Idle RPM Adjustment

Recommended engine idle RP M is 1200 +/- 200. If the engine idle

speed is unsatisfactory and all other conditions are favorable, the

carburetor can be adjusted as follows:

1. Start the engine and allow it to warm up for

approximately five minutes.

2. Place the transmission in gear with the

parking brake applied.

3. Adjust the carburetor idle screw (1) in or

out until the desired idle RPM is reached.

Turning the screw in (clockwise) will raise

RPM. Turning the screw out

(counterclockwise) will lower RPM.

3/8″-1/2″ (.95-.1.3 cm)