Owner's Operation and Maintenance Manual

A-- 50
MAINTENANCE
Track Inspection
Using a hoist or jackstand, safely
lift and support the rear of the
snowmobile off the ground. Ro-
tate the track by hand to check for
any possible damage.
To inspect track rods, carefully
examine the track along the en-
tire length of each rod, bending
the track and inspecting for
breakage. The three most com-
mon places where breakage oc-
curs are shown in the illustration.
Check the track clips and tighten
if loose.
If any rod damage is found, the
track should be replaced.
NOTE: The 120 XCR track has molded in track clips. It is common for a thin layer
of rubber to detach from clip area and peel off during initial use.
WARNING
Never make this maintenance check with the engine running, as serious
personal injury can result.
21312
Track window
Lug
WARNING
Serious personal injury or death may occur. Broken track rods are a serious
hazard, since they can cause a rotating track to come off the machine. Never
operate or rotate a torn or damaged track under power.