Owner's Operation and Maintenance Manual

A-- 29
OPERATION
Pre-ride Warm-Up
The following steps must be
taken to ensure proper warm-
up of the engine, drive train and
track.
With the snowmobile securely
supported by the rear bumper,
and with a minimum clearance
of 4″ (10 cm) from the ground,
use the following procedure.
1. Start the engine and allow
it to warm up two to three
minutes.
2. Engage the drive system abruptly and allow it to rotate the track several
revolutions. NOTE: The outside temperature will determine the amount of
track warm-up required.
3. Shut off the engine and remove the rear support.
4. Grasp the skis by their front loops and move from side to side. This will loosen
frozen snow from the ski bottoms, allowing the machine to move forward more
easily.
5. The engine, drive system and track are now properly warmed up and the
machine can be driven following normal safety practices.
NOTE: It is up to you, the parent, to teach your child the proper and safe way to
ride a snowmobile. You must set boundaries and adhere to them, keeping your
child’s safety foremost in your mind. Never allow your child to operate this machine
without adult supervision.
WARNING
Be sure the rear support is stable. Stand clear of the front of the machine and
the moving track. Never hold the snowmobile up or stand behind it while
performing this procedure. Do not use too much throttle during warm up or
when track is free-hanging. A loose track or flying debris could cause serious
personal injury or death.