User Manual

ManualsBrandsPOLARIS GPS ManualsCamera IntegrationPOLARIS GPS Ford Sync 3 Camera Integration

Ford Sync 3 Camera Integraon

Installaon and User Manual

Thank you for purchasing the Ford Camera Integraon Module.

Before installing be sure to read these instrucons.

Warranty for this product is 2 years from date of purchase, however warranty is void if:

• Unit is tampered with, damaged or modied

• Any cables in the kit are cut or modied

• Reverse Camera is subjected to overvoltage

Warranty Terms

The Ford Integraon module is covered by warranty for 2 years and includes:

• Defecve Equipment • Defecve cables

Not covered under warranty:

• Abuse

• Improper installaon

• Alteraons to cables

• Accidents

• Water damage

• Improper use

• Labour

• Postage costs

Summary of content (12 pages)

PAGE 1
Ford Sync 3 Camera Integration Installation and User Manual Thank you for purchasing the Ford Camera Integration Module. Before installing be sure to read these instructions.
PAGE 2
Installation Notes  This module is to suit the Sync 3 Ford screens.  The wiring and installation of this unit requires special technical skill and experience. If you do not feel confident installing this product or do not have the level of skill necessary, please contact Polaris on 1300 555 514 so we can refer to a recommended installer.  To avoid short circuit in the electrical system, ensure that the negative battery cable is disconnected before installation.
PAGE 3
How to pull the dash apart to access OEM Head Unit & Screen This is the recommended order to pull the dash apart: Please see individual photos below corresponding with their number above: 1 2 1. Pull out right hand side small panel 2. Pull out left hand side small panel 3 3. Put trim tool underneath the long panel attached to left of OEM screen air vent and pop out 4 3. Remove entire panel 3 3 3. Put trim tool under left of OEM screen air vent and pop out 4 4.
PAGE 4
5 5 5. Place your hand on left side of the long trim and loosen by popping out carefully 5 5. Place your hand on the long trim directly underneath the monitor and loosen by popping out carefully 5. You should now be able to remove the entire panel with ease This is the recommended order to pull the final trim off: Please see individual photos below corresponding with their number above: 1 1. Unscrew the top 2 screws 2 2. Unscrew the 2 middle screws 3 3. Unscrew the 2 bottom screws 4 4.
PAGE 5
1. Remove the 2 screws underneath the air conditioning panel 2. Pull the trim off starting at the BOTTOM. Pull gently as you will need to disconnect the plugs from the back of the air conditioning panel 3. Remove all plugs from the back of the air conditioning control panel, remove trim and set aside 4. Remove 8 screws to access the back of the monitor and head unit 5. On the back of the OEM monitor, remove linking cable (may look different in newer models, please see PAGE 6) 6.
PAGE 6
Linking Cable—Newer Models 1. In some of the newer models, the linking cable will look a little different 3. Proceed to plug in our linking cable 2. Undo the 4 bigger screws to remove the top plate to access the linking cable & unplug 4.
PAGE 7
Some newer models have a different linking cable setup (see page 6). DipSw Settings The DipSw settings are already pre-set for a Ford Ranger. If you are fitting into a another Ford vehicle, please make sure you refer to the DipSw setting and change accordingly.
PAGE 8
DipSw Settings (continued) DipSw UP DOWN 1 2 3 4 X X X X 5 6 7 8 See Below Ford Ranger with Sync 3: 2016 – 2021 DipSw UP DOWN 5 6 7 8 X X X X Ford Ranger with musical note on steering wheel (see figure 1.) DipSw UP DOWN 5 6 7 8 X X X X 5 6 7 8 X X X Ford Everest: 2016 – 2021 DipSw UP DOWN X Figure 1. If your Ford Ranger has a musical note on the left hand side of your steering wheel, please make sure 5,6,7 & 8 DipSw settings are set to ON.
PAGE 9
Camera Wiring Polaris Caravan Camera Kit—All Polaris parts Caravan Camera Kit—Converting A frame generic style plug to Polaris WOZA socket Caravan Camera Kit—Using an adaptor to plug into A frame generic style plug (NO WOZA setup) 7M EXT. GENERIC CAM TO POLARIS CAMERA ADAPTOR Front Camera Setup—All Polaris parts Don’t forget to cut the image control wire to change the camera image to forward facing & also pick up power for the camera. CA05 RCA ADAPTOR 7M EXT.
PAGE 10
Programming Reset Interface Setup Front Camera 0 15 5 20 Reverse Camera OEM EXT Side View Parking Assist ON AVM Exit OFF Version ON OFF ON OFF Factory Reset Front Camera: Select 5 and select EXIT to save Caravan Camera: Select EXT and select EXIT to save Default settings out of box: Front Camera 0 / Reverse Camera EXT Important: The programming setup cannot be accessed in some of the newer 21.25 & 21.75 models.
PAGE 11
Caravan Camera & Front Camera (2 cameras) Hold in button for 3 seconds: Front Camera will appear first. Hold in appear.
PAGE 12
Camera Activation—Everest / Ranger with musical note SWC Ford Everest 2016—2021 Ford Ranger with musical note steering wheel control 12