Operation Manual

40 41
13. SWAP BETWEEN HEART RATE MODE AND
CYCLING MODE
Press simultaneously SET/START/STOP and SIGNAL/LIGHT.
14. STOP THE CYCLING MODE
YOU HAVE THE FOLLOWING TWO ALTERNATIVES TO STOP:
1. To stop the Cycling mode and enter Time mode:
Press SET/START/STOP to stop the stopwatch.
Press SELECT.
Press SELECT twice to return to Time mode. You can recall
the recorded information later (see
Recalling the
recorded information
).
2. To stop the Cycling mode and continue directly by recalling the
recorded training information, see Recalling the recorded
information.
10. STORE HEART RATE, SPEED AND
CADENCE/ALTITUDE
Heart rate (bpm), speed (km/h or mph) and cadence* (rpm) /
altitude** (m/ft) are stored automatically according to the preset
recording interval.
To set the recording interval, see Setting the recording
interval.
* For cadence separately sold Polar Cadence Sensor is required
** For altitude separately sold Polar Altitude Sensor is required.
11. RESET THE STOPWATCH
First press SIGNAL/LIGHT several times until you see the
stopwatch displayed. Press SET/START/STOP to stop the
stopwatch. Then press and hold SET/START/STOP until all
stopwatch digits are back to zero (alternatively the countdown
timer is back in preset starting time). Release the button. The
current file is deleted and you can start the stopwatch and
recording again.
12. RESET THE CYCLING INFORMATION
The following information in the cycling information loop is
cumulative:
- trip
- total riding time
- average speed
- maximum speed.
To reset these values, the stopwatch has to read 00:00 0. By
pressing SIGNAL/LIGHT select the value, which you want to reset.
Then press and hold SET/START/STOP until the digits are back to
zero. In case of total riding time, you should press and hold
the button for 6 seconds.