Operation Manual

38 39
5. ILLUMINATE THE DISPLAY
Press and hold SIGNAL/LIGHT to illuminate the display.
6. SWAP HEART RATE LIMITS
When the stopwatch is running press SELECT to activate new
limits. Release. The new activated limits are displayed for 5
seconds.
7. CHECK SPLIT/LAP TIME
WITH AVERAGE HEART RATE
Press STORE/LAP/RECOVERY.
Split/lap time with average heart rate of the lap appears in the
display for 5 seconds.
The number of the next lap appears in the display.
8. START RECOVERY CALCULATION
Press and hold STORE/LAP/RECOVERY until you hear three long
beeps. Release. For details see In the heart rate mode; Start
recovery calculation.
9. START THE TIMERS
Timers start running automatically once you start the stopwatch.
Timers alternate in the following order: Timer 1, Timer 2, Timer 3,
Timer 1, Timer 2, Timer 3, etc. Timers stop running as you stop
the stopwatch.
3. CHECK CYCLING INFORMATION
The following information is available by pressing SIGNAL/LIGHT in
the Cycling mode:
Trip Stopwatch Time of Day Average speed
Meters / feet Maximum Total riding Odometer
ascended* speed time
* Separate Polar Altitude Sensor required.
Next time you start the Cycling mode, on the top you will see the
feature you used last in your previous workout before stopping the
stopwatch.
In the cycling information loop the displayed TZ symbol
indicates that the stopwatch is running.
Always when starting the recording (stopwatch), regardless
which out of the eight available features was used last, the
stopwatch will show up for a few seconds.
4. START/STOP THE STOPWATCH
Press SET/START/STOP to stop and restart the stopwatch.