Operation Manual

30 31
3. Start the code search in Time mode by pressing SELECT.
The Receiver starts searching for coded
transmission for max. 30 seconds.
M and INT scan on the display indicating the memory
available with the chosen recording interval.
The coded heart rate information appears in
the bottom line of the display.
Coded transmission is indicated by borders
around the heart symbol.
If the code search was not successful, 00 appears in the display.
Restart the measurement from Time mode and follow the above
mentioned precautions during the code search.
4. Start the stopwatch by pressing SET/START/STOP.
Stopwatch starts running and you hear a long beep.
Automatic recording starts.
Display is illuminated for a few seconds.
Display in the Heart rate mode
• Target Zone indication
• split/lap time
• Primary Time Display
• heart rate
• memory left / recording interval / lap
Display in the Cycling mode
• Target Zone indication
• cycling info loop*
• Cycling mode indication
• speed
• heart rate
• memory left / recording interval /
lap / cadence** / altitude***
* Cycling info loop includes Trip, Stopwatch, Time of Day, Average
speed, Odometer, Total riding time, Maximum speed, meters /
feet ascended (separate Polar Altitude Sensor required)
** Separately sold Polar Cadence Sensor required.
*** Separately sold Polar Altitude Sensor required.
Always when cycling, attach the Receiver carefully on the
Polar Bike Mount as instructed on page 8.
5. You can now start exercising with your heart rate monitor.
Quick start from the Time mode with a bike symbol starts
the Cycling mode: wear the Transmitter and Receiver as
described in
Getting going and press and hold STORE/
LAP/RECOVERY. Release the button and the stopwatch
starts running.
Quick start from the Time mode without a
bike symbol starts the Heart rate mode.