Operation Manual

12 13
SETTING THE ALARM
Alarm symbol is flashing.
1. Press SIGNAL/LIGHT to set the alarm on or off.
= alarm is on
= alarm is off
2. Press STORE/LAP/RECOVERY to lock
your selection.
AM/PM starts to flash.
3. Press SIGNAL/LIGHT to select AM or PM.
4. Press STORE/LAP/RECOVERY to lock
your selection.
The hours start flashing.
5. Press SIGNAL/LIGHT to select the desired hour.
The digits run faster if you press and hold SIGNAL/
LIGHT. Release the button when the desired value is
approaching.
6. Press STORE/LAP/RECOVERY to lock your selection.
The minutes start flashing.
7. Press SIGNAL/LIGHT to select the desired minutes.
8. Press STORE/LAP/RECOVERY to lock your selection.
SET starts to flash.
Alarm symbol starts to flash.
You have the following two alternatives to continue:
1. To enter the time setting mode, press SET/START/STOP.
TIME appears in the display.
AM (alternatively the hour) starts to flash.
Continue from Setting the time.
2. To return to Time mode, press SELECT.
When the alarm comes on it will sound for one minute or you
can turn it off by pressing STORE/LAP/RECOVERY.
SETTING THE TIME
AM/PM (alternatively the hours) is/are flashing.
1. Press SIGNAL/LIGHT to select AM or PM.
2. Press STORE/LAP/RECOVERY to lock
your selection.
The hours start flashing.
3. Press SIGNAL/LIGHT to select
the desired hour.
4. Press STORE/LAP/RECOVERY to lock your selection.
The minutes start flashing.
The seconds go to zero.
5. Press SIGNAL/LIGHT to select the desired minutes.
6. Press STORE/LAP/RECOVERY to lock your selection.
The seconds start running.
AM/PM or the hours start flashing.
You have the following two alternatives to continue:
1. To enter the date setting mode, press SET/START/STOP.
DATE appears in the display.
The day start to flash.
Continue from Setting the date.
2. To return to Time mode, press SELECT twice.