Getting Started Guide

Changing Polar H1 Heart Rate Sensor
Battery
1. Lever the battery cover open by using the
clip on the strap.
2. Remove the old battery from the battery
cover with a suitable sized small rigid stick
or bar, such as a toothpick. A non-metal tool
is preferable. Be careful not to damage the
battery cover.
3. Insert the battery inside the cover with the
negative (-) side outwards. Make sure the
sealing ring is in the groove to ensure water
resistance.
4. Align the ledge on the battery cover with the
slot on the connector and press the battery
cover back into place. You should hear a
snap.
This crossed out wheeled bin marking shows
that Polar products are electronic devices and
are in the scope of Directive 2012/19/EU of the
European Parliament and of the Council on
waste electrical and electronic equipment
(WEEE) and batteries and accumulators used in
products are in the scope of Directive
2006/66/EC of the European Parliament and of
the Council of 6 September 2006 on batteries
and accumulators and waste batteries and
accumulators. These products and
batteries/accumulators inside Polar products
should thus be disposed of separately in EU
countries.
ENGLISH
Important Information 13