User Guide

19
Manually Programming a User Name
In the Time of Day screen, you can choose between four
alternatives in the top row. You can switch between them by
pressing and holding the upper right button for each selection.
Your choices are:
1. Date
2. User name (E600 as default, can be set as described below)
3. Monitor ID (set to zero by default, can be set via Computer
Upload)
4. Logo (Polar logo as default, can be set via Computer Upload)
You can manually program a user name into your E600. For
example, if you teach at George Washington Middle School, you
might put "GWMS".
Note: You can also do this more quickly by uploading this data
from your computer.
Programming a User Name
1. In the Time of Day screen, repeatedly press and hold the upper
right button until "E600" appears on the top row. (It is right
after the date display.)
2. Press and hold the signal button on the upper left side. Time of
Day will disappear. You can now start setting the user name.
3. You can set the first character by scrolling with either button
on the right side.
4. When you are satisfied with the character, you can lock it in
with the red button. At this time the next character will begin
to flash. Each character can be set in the same way.
5. When everything is set to your liking, you can lock in the
entire user name by pressing and holding the blue button.
Note: If you have made a mistake, or if you want to change
the entire user name, press and hold the blue button to get to
the Time of Day, and start again from step one.