User Guide

17
(either 5,15 or 60) followed by “Sec” for seconds. The lower
line will show the amount of time left for recording.
4. On this screen, the only digits available for setting will be the
number of seconds on the middle row (which are now flashing).
You can adjust this value by using either of the right side
buttons. Notice that as you change the recording interval the
available memory, displayed on the bottom line, will shrink or
expand.
5. Lock in your choice by pressing the red button.
6. You can return to the Time of Day by pressing and holding the
blue button.
Watch Set
The Watch Set loop is accessed from the Options mode.
You can use it to set the correct time of day and date.
Programming the Time of Day
1. From Time of Day display, press the upper right button two
times. Your display will read, "OPTIONS".
2. Press the red button once and the upper right button twice.
Your screen will read, "WATCH SET".
3. Enter this mode by pressing the red button two times. "TIME"
will be displayed on the top row. The middle line will show the
default time of day and the number 12 or 24 will be flashing
on the lower line. By pressing either button on the right side
you can switch it to the setting whichever is appropriate. Press
the red button one time to lock in your selection. If you have
picked the 12 hour time clock, the am (or pm) will beginto
flash.
4. By pressing either button on the right side, you can pick
whichever is appropriate.
5. Press the red button once to lock in your choice and the
hours will begin to flash.
6. Using either button on the right will alter the value of this
number. Lock in your choice by pressing the red button.
The minutes will begin to flash.