User Guide

16
Memory Set
Programming the Heart Rate Recording Intervals
In the measure mode, your receiver will always display your
current heart rate. But, depending on your needs, you can set it
to record the heart rate at intervals of 5, 15 or 60 seconds. A
longer interval will give you more recording time, but a shorter
interval will allow you to capture more heart data in a given
amount of time. The preprogrammed setting is 15 seconds.
Recording Interval Maximum Recording Time
5 sec 22h 10 min
15 sec 66h 32 min
60 sec 99h 59 min
You can save up to 99 separate files but the ultimate number will
be governed by the length of the file and the recording rate.
1. From the Time of Day display, press the upper right button two
times. The display will read, “OPTIONS.”
2. Press the red button once and the upper right button one
time. The display will read, “MEMORY SET.”
Note: In the lower right corner of the display you will see 5,
15, or 60. This is the number of seconds your receiver is
currently set at to record.
3. Press the red button one time. You will see “Rec. Rate” on the
upper line. The middle line will show the recording interval
7. Using either button on the right will alter the value of this
number. Lock in your choice by pressing the red button.
8. Now you can return to the Time of Day by holding down the
blue button, or you can press the upper right button once to
set Timer 2. This timer is set in exactly the same way as Timer 1.
When you have set Timer 2, press and hold the blue button to
return to the Time of Day.
Note: If Timer 1 is set to OFF, Timer 2 will not be displayed.