Operation Manual

18 19
4. Press SIGNAL/LIGHT to select the desired Secondary Time
Display. The alternative you choose can be activated in the
middle row of the display during the heart rate measurement by
bringing the face of the Wrist receiver next to the Polar logo of
the Transmitter for a moment.
Choose from the same alternatives as for the Primary Time Display.
However, note that the option which you chose for the Primary Time
Display is not available when setting the Secondary Time Display.
5. Press STORE/LAP/RECOVERY to lock your selection.
You have the following two alternatives to continue:
1. To start setting the Timers 1, 2 & 3 press SET/START/STOP.
The first block of the graphic bar representing the setting of
the Timers 1, 2 & 3 starts to flash.
Continue from Setting the Timers 1, 2 & 3.
2. To return to Time of day display, press SELECT twice.
SETTING THE PRIMARY AND
SECONDARY TIME DISPLAY
The Primary Time Display symbol 1 and 00:00 0
(alternatively time of day or the preset value of the
timer) is flashing.
1. Press SIGNAL/LIGHT to select the desired
Primary Time Display. The alternative you
choose will be displayed in the middle row
during the heart rate measurement.
CHOOSE FROM THESE ALTERNATIVES:
CHRONO 00:00 0
Displays total exercising time during heart rate
measurement.
TIME Time of Day (for example 1:52 PM/13:52)
Displays time of day during heart rate
measurement.
TIM 1 Setting of Timer 1 (for example 0:10 00)
Displays during heart rate measurement the
counting down of the timers after one another
depending on how many timers you have set.
This alternative is available only if you have earlier
set at least Timer 1.
2. Press STORE/LAP/RECOVERY to lock
your selection.
3. Press SET/START/STOP to start setting the
Secondary Time Display.
The Secondary Time Display symbol 2 and
00:00 0 (alternatively time of day or preset
value of the timer) start to flash.