Tus neeg siv phau ntawv

Modifying a Gateway
To modify the IP address, port and/or name of a previously added OTGW you can use the Modify
OpenTherm Gateway page as follows:
• Go to Plugins > OTGW Plugin > Modify OpenTherm Gateway.
• Follow the steps:
o Choose Continue at the introduction step.
o Pick the OTGW you want to modify from the dropdown. Choose Continue.
o Modify the IPv4 address of the OTGW, if needed. Choose Continue.
o Modify the port number that goes with that IP address, if needed. Choose
Continue.
o Modify the name for this OTGW, if needed. Choose Continue.
o If you want to modify the Location (room) of the features to the new IP
address/port just like when you added the OTGW, choose Modify
location(s)/room(s) to the new IP address/port. If since adding the OTGW you
have modified the location(s) to something custom, you may want to choose
Leave location(s)/room(s) as they are instead. Choose Continue.
o Confirm the change and choose Modify Now. Features and settings will then be
modified to use the new IP/port/name (unless invalid or already in use).
Removing a Gateway
To completely remove an OTGW from the settings and remove its device and features you can use
the Remove OpenTherm Gateway page as follows:
• Go to Plugins > OTGW Plugin > Remove OpenTherm Gateway.
• Follow the steps:
o Choose Continue at the introduction step.
o Pick the OTGW you want to remove from the dropdown. Choose Continue.
o Confirm the removal and choose Remove Now. Features and settings will then be
removed.
Donate
As the Donate page (Plugins > OTGW Plugin > Please Donate) explains, I decided to make the plugin
free. Considering the amount of work that went into it (research, writing code, testing, etc.) and
expected support/updating in future, this would have been a paid plugin.
The reason for this plugin being released as a free plugin is simple. Schelte Bron has released the
OTGW without the intention to make money. Its PCB design, firmware, software and sources are
available for everyone, free of charge.
If you are willing to donate, please first consider to donate to Schelte Bron. There is a
link to his
PayPal at the bottom (Feedback) of this page on his site.
If you are willing to donate to me I'm asking you to buy my paid plugin: MiLight (LimitlessLED). That
way HomeSeer will get their share too, which I think is fair.
Thank you for your support.