Owners manual
©2015 POISON SPYDER CUSTOMS 951-849-5911•WWW.POISONSPYDER.COM
INSTALLATION INSTRUCTIONS INST-45-12-RDA_A
YJ-CJ Lower A-Pillar
Light Mount
IMPORTANT: Thank you for purchasing this Poison Spyder product. Please read through this entire document before proceeding with installation. If you are not
confident in your mechanical skills, please seek the help of a professional to perform the installation. Check your packages immediately upon arrival to ensure that
everything listed is included, and to check for damage during shipping. If anything is missing or damaged, or if you need technical assistance with any aspect of
this installation, call Poison Spyder at (951) 849-5911 as soon as possible. This document last updated May 2015.
APPLICATIONS
These installation instructions apply to the following
Poison Spyder products:
45-12-RDA JK Lower A-Pillar Light Mounts
PARTS LIST
Please check your packages immediately upon arrival
to ensure that everything listed is included, and to
check for damage during shipping. If anything is
missing or damaged, call Poison Spyder at (951) 849-
5911 as soon as possible.
(1) Driver Side YJ-CJ Lower A-Pillar Light Mount
(1) Passenger Side YJ-CJ Lower A-Pillar Light Mount
(2) YJ-CJ Lower A-Pillar Light Mount Rubber Liners
(1) YJ-CJ Lower A-Pillar Light Mount Hardware Kit
PN: 45-12-RDA includes:
(4)
5/16-18 X 3/4 SS Button Head Cap Screw
(4) 5/16-18 Flange Nut
INSTALLATION NOTES
•This product is designed primarily for mounting
the Rigid Industries Dually or Dually D2 LED lights. No
guarantee is made regarding fitment of other brands of off-
road or auxiliary lights, however it will likely work with most
lights that are in a compact housing. The light mounting hole
is 7/16”.
•Remove the two Torx bolts (T40 driver bit) on the
front-ward side of the lower half of the windshield hinge.
There are hex nuts (1/2” wrench) on the opposite ends of
these Torx bolts, behind the dash. Its tricky to get to them
without un-bolting the dash, but enlisting the help of a friend
or child with small hands may do the trick.
•Place the rubber liners between the mount and the
lower A-pillar, to protect the Jeep’s paint.
•Use the provided stainless steel button head cap
screws (3/16” hex key) and flange nuts (1/2” wrench) to
secure the light mount to the lower windshield hinge. Flange
nuts are provided to make it easier to load them into the box
end of a 1/2” combination wrench in order to hold them up
in place behind the dash during the install.