Owners manual

INSTALLATION INSTRUCTIONS
Poison Spyder Customs • JK LED Taillight Harness Installation Page 2
©2014 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
FIGURE 1
3. With your thumb, press on thereleasetab
ofthetaillightharnessplug,andseparateit
fromthevehicleharness.SettheOEtaillight
assemblyaside.
FIGURE 2
NOTE: At this point, provisions will have to be
made for physically mounting the 4” round LED
taillight. In most cases, this means installing
Poison Spyder Crusher Corners. Instructions
for doing that are not included here. These
instructions continue with the assumption that
the Jeep is now ready to mount the 4” round
LED taillights (and 2-1/2” round reverse lights,
if applicable)
NOTE: If installing Poison Spyder’s LED License
Plate & 3rd Brake Light in conjunction with this
installation, insert the procedures included with
that product into the installation process here.
4. Plug the Poison Spyder LED Taillight
HarnessintotheOEtaillightconnector.
FIGURE 19
5. Secure the gold anodized resistor heat
sinkintoplaceinsidetheJeep’scornercavity.
Thismaybedonebyusingacoupleofsmall
self-tappingsheetmetal screwsanda long
driverextensionforyourdrill,tosecureitto
the at surface inside the cavity.  Be sure
not to chose a surface where the ends of
thesheetmetalscrewswillprotrudeintothe
Jeep’sinterior.
FIGURE 20
6. If installing the LED License Plate & 3rd
BrakeLight,routethelonggraylicenseplate
lightleadtowhereveryouaregoingtomount
thelicenseplatelight,typicallyatthecenter
ofthesparetireonthesparetirecarrier.To
route the wire to the exterior of the Jeep,
reachinside theJeep’scornercavity,down
tothe “oor”inside. Thereisaholeinthis
oorunderathickpieceoffoaminsulation.
Thisholecanbeusedtoroutethewiringto
theexterioroftheJeep.
7. Route the back-up light extension
harness(es),ifneeded.Therearetwoplugs
providedontheharnessforthese.Forbackup
lightsmounteddowninthebumper,usethe
24”extensionharnesses androutethrough
the holeinthe oor of thecornercavity as