Owners manual
INSTALLATION INSTRUCTIONS
©2009 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
Poison Spyder Customs •
JK4-DOORB-PILLARCOVERINSTALL Page2
4. Use the 25/64th drill bittonishopeningup
theholes.Takeyourtimedrillingtheseholes,
thelargerdrillbitmaycatchanddistortthe
hole.Makesureyoudonotdrillthroughthe
innerpanel.
5. Inside the Jeep’s B-Pillar, atthecenterhole
location,thereisaverticalsheetmetalange
that must be trimmed in order to provide
clearanceforthenut-sertthatwillbeinstalled
there.CAREFULLYusethediegrinderwith
rotary burr bit, inserted through the hole,
to grind away this interior obstruction. Be
extremelycarefultonotletthetoolgetaway
fromyouandfoultheedgesoftheholeyou
drilled.Test-tone of theprovide nut-serts
intotheholetoensurethatyou’veprovided
enoughclearance.
6. Apply some touch up paint to the areas
wherebaremetalisexposed,attheedgesof
eachholeyoudrilledaswellasthegrinded
surfaceinsidethecenterhole.Thiswillaid
inthepreventionofcorrosion.
7. Using the nut insert toolandtheseparate
instructions provided, install nut-serts into
theholesyoujustdrilled.Donotovertighten
thenutinserts;thiswillcausethemtodistort
andnotfastentothebodycorrectly.
FIGURE 5
8. You may need to use a soft dead-blow
hammerorrubbermallettogentlytapeach
installednut-serttoensurethatitssurfaceis
ushwiththesurroundingsheetmetal.
9. Remove any protective masking tape
that was applied at the beginning of this
procedure.
10. Install the B-Pillar Cover usingtheprovided
1/4” stainless steel at head cap screws.
Make sure you place a small amount of
anti-seize on the threads of each fastener.
Donotovertightenthesefastenersandrisk
“spinning”theinstallednut-sert.
11.Repeattheprocedurefortheoppositeside.
Congratulations, you have completed installation
of your JK B-Pillar Covers.