Owners manual

INSTALLATION INSTRUCTIONS
©2011 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
JK 4-DOOR B-PILLAR COVER INSTALLATION
Thank you for purchasing Poison Spyder B-Pillar
Covers for your Jeep JK 4-Door. Installation
is fairly simple with the right tools and good
mechanical abilities. If you are not condent in
your mechanical skills, please seek the help of a
professional to perform the installation. Please
read through these entire instructions before
proceeding with installation.
PARTS LIST
(1) Driver side B-Pillar Cover
(1) Passenger side B-Pillar Cover
(1) Nut Insert installation tool
(12) 1/4-20 nut-sert
(12) 1/4-20X3/4SSatheadcapscrew
TOOLS NEEDED
• 1/2” drill motor
• 1/4” drill bit
• 25/64” drill bit
• Diegrinderwithsmallcarbideburrbit
• Hammer
• 1/4”centerpunch
• 5/32”hexkey
• 1/4”driveratchet
• Anti-seizecompound
• Finetipfeltmarker
• Maskingtape
• Touch-uppaint
• Afriendtoholdpartsinplace
IMPORTANT: Do not attempt this installation
in ambient temperatures below 80°F (26
°C). Aluminum shrinks or expands almost
imperceptibly at different temperatures. Installing
these items at a warmer temperature will ensure
that they do not try to expand and buckle when
ambient temperatures rise.
NOTE: This product is designed to be installed
along with Poison Spyder 4-Door JK Body
Armor or Brawler Rockers. These instructions
assume that the Body Armor or Brawler Rockers
have already been installed. If installing without
these, or in conjunction with other manufacturers’
rocker armor, it is the installer’s responsibility to
make any necessary modications.
INSTALL PREPARATION:
1. Park vehicle on a level  surface and set
theparkingbrake.Youwillwanttoweareye
protectionbeyondthispointintime.
3. Apply masking tape along the vertical
edges of the Jeep’s B-Pillar to protect the
paintnishduringinstallation.
INSTALLATION PROCEDURE
1. Hold the B-Pillar Cover againsttheJeep’s
B-Pillarandpositionit.MakesuretheB-Pillar
Coveriscenteredbetweentheverticaledges
oftheJeep’sB-Pillar.Positionitverticallyso
thatitisveryslightlyapartfromthetopedge
of your previously-installed JK BodyArmor
orBrawlerRockers.Youmayuseacouple
ofpenniesorathinpieceofsheetmetalor
cardboardto spacetheB-Pillar Coverfrom
theBodyArmororBrawlerRocker.Havea
friendholdtheB-PillarCoverinplace.
2. Usethene-tipfeltmarkerorcenterpunch
tomarkeachoftheholelocations,usingthe
B-PillarCover.Be extremelycarefulto not
allowtheCovertomovewhiledoingthis.
3. Use the 1/4” bit anddrillmotortodrillpilot
holesateachoftheholelocations.