Owners manual
©2015 POISON SPYDER CUSTOMS 951-849-5911•WWW.POISONSPYDER.COM
POISON SPYDER CUSTOMS INST-17-08-200_A • JK Brawler Rockers™ 5
21. Removethemaskingtapefromthe front and rear
fender flares.
22. Tightenallofthe1/4-20X 3/4 flat head cap screws
to no more that 10 ft./lbs.
23. Installthesupplied3/8-16clip-nutsinto the nut
flanges along the bottom of the Body Armor Upper Piece.
Make sure that the extruded barrel of the clip-nut points
downward through the hole in the flange.
24. Use an 18mm wrench to remove the nuts and
washers from the bottom of the body mounts below the
rocker panels. There will be 3 such body mounts on a
4-door JK, and 2 on a 2-door. Set the nuts and washers
aside, they will be re-installed later.
25. HangtheBrawlerRockerLowerPiece on the nut
flanges of the Body Armor Upper Piece. Install a supplied
3/8-16 X 1 flat head cap screw at each end of the Brawler
Rocker to temporarily hold the part in place. Leave these
two fasteners loose at this time. The help of a friend, or the
use of a floor jack to assist in holding the piece up may be
helpful with this step.
26. Pushthelowerendofthe Brawler Rocker Lower Piece
upward so that the exposed ends of the body mount bolts
slip through the corresponding slots on the Brawler Rocker.
Reinstall the body mount washers and nuts, leaving them
slightly loose at this time.
27. Install the remaining 3/8-16 X 1 flat head cap
screws into the holes along the top surface of the Brawler
Rocker Lower Piece.
28. Have a friend push against the Brawler Rocker
Lower Piece, or use a pry-bar against a closely-placed
stationary object, to snug the Lower Piece up against the
side of the Body Armor Upper Piece.
29. Tightenallofthe3/8-16X 1 flat head cap screws
along the top of the Brawler Rocker Lower Piece, as well
as the 2 or 3 body mount nuts underneath, while ensuring
that the Brawler Rocker Lower Piece remains tight to the
Body Armor Upper Piece. There should be no gap along
the seam where the two pieces meet.
30. Repeattheprocedurefortheother side.