Owners manual

©2015 POISON SPYDER CUSTOMS 951-849-5911•WWW.POISONSPYDER.COM
POISON SPYDER CUSTOMS INST-17-08-200_A • JK Brawler Rockers™ 4
If you “spin” a nut-sert: That is, if it loses its grip due to
over-tightening or improper installation, the quickest,
easiest x is to use a MIG welder to place a small
tack weld at the edge of the nut-sert ange. Before
applying the tack weld, sand or grind the paint from a
very small area of the sheetmetal where the tack weld
will be. Then insert a screw into the nut-sert to protect
the threads from weld splatter. Only apply a very small
tack or two, as you do not want to heat up and deform
the nut-sert or the sheetmetal. Then grind the tack(s)
smooth and apply touch-up paint to prevent rust.
11. InstalltheBodyArmorUpperPiece using two 1/4”
flat head bolts. Make sure you place a small amount of
anti-seize on each bolt. Do not over tighten the bolts; for
this step you will only need to snug them up.
12. Double check the tment to make sure you are
happy with it.
13. Usingthe1/4”drillbit,drill the rest of the mounting
holes using the Body Armor Upper Piece as your drill
guide. Make sure you do not drill through the inner panel.
14. Remove the Body Armor Upper Piece and set
aside.
15. Usethe25/64thdrillbitand open up the holes you
just drilled. Take your time drilling these holes; the larger
drill bit may catch and distort the hole. Make sure you do
not drill through the inner panel.
16. Apply some touch up paint to the areas where
bare metal is exposed; this will aid in the prevention of
corrosion.
17. Installa1/4-20nut-sertintoeach of the holes that
were drilled out to 25/64”, using the same procedure that
was outlined in earlier steps.
18. Removethetapefromtheback of the Body Armor
Upper Piece.
19. (Optional)Ifyoupurchasedtherubber liners, they
will need to be placed on the back side of the Body Armor
Upper Piece. Use a couple of bolts to help hold the liner
in place.
For the final install it is helpful to have someone assist you
with lining things up.
20. Install the Body Armor Upper Piece using 1/4-
20 X 3/4 flat head cap screws. Make sure you place a
small amount of anti-seize on the threads of each cap
screw. Make sure you get all of the screws started before
tightening any of the bolts up. Do not over tighten the bolts;
for this step you will only need to snug them up.