Owners manual

©2015 POISON SPYDER CUSTOMS 951-849-5911•WWW.POISONSPYDER.COM
POISON SPYDER CUSTOMS INST-17-08-200_A • JK Brawler Rockers™ 2
• Read through instructions thoroughly before beginning
installation.
INSTALL PREPARATION:
1. Park vehicle on a level surface and set the emergency
brake. You will want to wear eye protection beyond this
point in time.
2. IfyourWranglerisaRubicon edition or it is equipped
with rocker protection or steps, they will now need to be
removed. Factory installed rocker protection is held on by:
a. 2-Door: four (4) nuts in the pinch weld ange
(Figure 1) and two (2) bolts that go into the
bottom of the tub (Figure 2).
b. 4-Door: six (6) nuts in the pinch weld ange
(Figure 1) and three (3) bolts that go into the
bottom of the tub (Figure 2).
Using the 1/4” drive ratchet, 10mm socket and the
13mm socket remove the hardware that fastens the rocker
protection to the Jeep.
Remove the factory rocker protection from the Jeep by
gently pulling it away from the tub.
3. Applymaskingtapeontothefront and rear fender
flares, and on the Jeep’s body tub sheetmetal where the
Body Armor Upper Pieces will attach. You will want to
make sure you apply the tape from the bottom of the flare
up at least ten (10) inches. This step will help eliminate
scratches during installation.
4. Apply several pieces of tape (about three inch
sections) to the back of the Body Armor Upper Pieces. This
step will help eliminate scratches during installation.
INSTALLATION PROCEDURE
NOTE: Some of the following photos depict the
installation of a different product, Poison Spyder JK
Body Armor. For these steps, however, installation
is identical to the Body Armor Upper Pieces in the
Brawler Rocker kit.
1. Startwiththedriversside.Open the door(s) and
hold the Body Armor Upper Piece up and position it on the
tub. Make sure the gap around the door is equal front to
back and the body armor is level to the bottom of the door.
See figure 4. Use the bar clamps to clamp the Body Armor
Upper Piece into place (with the door open you can clamp
through the door opening).
2. Usethe1/4”bitanddrill motor to drill the first two
mounting holes using the Body Armor Upper Piece as your
drill guide. Use the forward and rearward most holes.
Make sure you do not drill through the inner panel.
3. Remove the Body Armor Upper Piece from the
Jeep and set aside.