Owners manual

POISON SPYDER CUSTOMS INST-17-66-010_A • JK TrailGate™ 9

39. Close the TrailGate and test the functionality of the

locking mechanisms. They will most likely require some

adjustment at this point.

40. The locking bars on the back side of the latches may

be adjusted by loosening the jam nuts on either side of the

locking bar, and moving it up or down the threaded stud.

41. Install the latch covers. Begin by removing the

u-brackets that were installed in a previous step, and

replace them with the latch covers using the M5-.8 X 50

hex head cap screws and #10 ﬂat washers provided. Note

that the latch covers are not identical, there is a right and

left cover. Make sure the rectangular notch for the latch is

oriented toward the bottom of the TrailGate™ (when gate

is closed).

42. Install the supplied Tailgate Hinge Delete Plates

into the spaces where the stock tailgate hinges had been

attached to the Jeep’s tub, using the stock tailgate hinge

bolts (not supplied).

43. Go back over the entire TrailGate assembly and

ensure that all hardware and fasteners have been fully

tightened.

Congratulations, you have completed the installation of

your Poison Spyder JK TrailGate!