Owners manual

POISON SPYDER CUSTOMS INST-17-66-010_A • JK TrailGate™ 8

32. Once again, remove the TrailGate from the Jeep,

this time leaving the Driver Side Hinge attached to the Jeep.

33. Remove the Passenger Side Hinge from the

TrailGate.

34. Use the supplied 1/4-20 X 1 SS Socket Head Cap

Screws, Flat Washers and Lock Nuts to attach the Passenger

Side Hinge assembly to the Jeep using the holes that were

just drilled. Access to the back-side of the drilled panel

can be reached through a hole in the ﬂoor of the Jeep, just

forward of the tailgate opening. Carpet may need to be

lifted for access.

35. Re-install the TrailGate by re-attaching it to the

hinges.

36. Attach the Limit Cables to the Gate Cable Brackets

using the supplied 1/4-20 X 3/4 SS Button Head Cap

Screws, Flat Washers and Lock Nuts. Do not fully-tighten

them yet.

37. Observe the cables and how they “lay” with the

TrailGate lying open. The TrailGate should be laying ﬂat,

with both cables equally taut. Adjustments to equalize the

cables may be made on the Driver Side Cable Bracket,

whose mounting holes are slotted to allow adjustment. Once

adjustments have been made, ensure that the hardware

fastening the Bracket to the Jeep is fully tightened.

38. The fasteners at both ends of both Limit Cables

may now be tightened, with the cable-ends of the eyelets

pointing straight toward each other while the cable is

taught.