Owners manual

POISON SPYDER CUSTOMS INST-17-66-010_A • JK TrailGate™ 5

...then insert a provided 1/4-20 X 1-3/4” SS Button Head

Cap Screw through a SS 1/4” Flat Washer, the eyelet end

of a Limit Cable, and through the Bracket and Spacer, into

the Nut-Sert. Do not fully tighten, as this hardware will be

further adjusted later in the procedures.

18. Assemble the hinge assemblies. Apply anti-

sieze lubricant to the shaft of a #10-24 X 2-1/2 SS Socket

Head Cap Screw, then use it to attach the Upper Hinge

and Lower Hinge into an assembly as shown in the photos.

Repeat the procedure for the second hinge assembly.

Note the orientation of the Upper Hinge and Lower Hinge

in relation to each other. With the two hinge halves

extended ﬂat, as shown in the photo below, the blind-

threaded holes in the Upper Hinge should be pointed in

the opposite direction of the counter-bored holes in the

Lower Hinge.

19. Attach the Hinge assemblies to the bottom of the

TrailGate using the supplied 1/4-20 X 1/2 SS Flat Head

Cap Screws.

To orient the hinges correctly, note the countersunk holes in

the TrailGate. The Hinge attaches to the side opposite the

countersinks.

20. Open the separate hardware packs that came

with the latches, and install the locking bar onto the

threaded stud of the latch.