Owners manual

POISON SPYDER CUSTOMS INST-17-66-010_A • JK TrailGate™ 4

12. Use a supplied 5/16-18 X 1 SS Button Head Cap

Screw to attach the Passenger Side Cable Bracket to the

newly-installed nut-sert. Make sure the bracket is oriented

as shown below. There are two holes in the bracket, for

this step the larger of the two holes is used.

13. Tighten the screw while holding the bracket

perpendicular to the edge of the tailgate opening. If the

Jeep is sitting on level ground, the bottom edge of the

Passenger Side Cable Bracket should be level (parallel to

the ground).

14. Use the remaining hole in the Passenger Side Cable

Bracket as a drill guide to drill a 1/4” (drill size) hole into

the Jeep’s body tub sheet metal. Be careful to hold the drill

level and perpendicular to the vertical surface of the Jeep

that you are drilling into.

15. Loosen the button head cap screw and swing the

Passenger Side Cable Bracket downward, away from the

new hole that was just drilled. Change bits and drill the

new hole out to 25/64”.

16. Install a 1/4-20 nut-sert into the hole that was

just created. We recommend using a professional nut-

sert installation tool. But if using the simple tool that

was provided in the kit, repeat the nut-sert installation

procedures that were detailed earlier in these instructions.

17. Swing the Passenger Side Cable Bracket back

into place so that the hole aligns with the newly-installed

nut-sert. Place the barrel-shaped Passenger Side Cable

Bracket Spacer between the Bracket and the nut-sert...