Owners manual

POISON SPYDER CUSTOMS INST-17-16-021_A • JK BFH™ II Front Bumpers 5

21. Use a drill motor and 1/2” bit to drill 1/2” holes

through the frame rails at each of the mounting holes,

using the bumper itself as your drill guide. Drill the upper

holes from the top and the lower holes from underneath.

Do not try to drill both the top and the bottom through the

same hole in the bumper, as you may not get the holes

properly aligned.

22. Install the supplied Grade 8 bolts with lock nuts and

ﬂat washers, into mounting holes, and tighten.

23. Re-install the grille by reversing the removal

procedure.

24. If you installed the OE fog lamps into the BFH™ II

bumper, plug the harness connectors back into the sockets

in the back of each lamp. Secure the wiring harness in

place by inserting the stock plastic harness clips into the

three holes along the upper-rear ﬂange of the BFH™ II

bumper.

25. If installing the optional BFH™ Disco Skid, follow

the instructions that came with the Disco Skid. If installing

a winch with Poison Spyder Winch Fairlead Mount, follow

the instructions included with the Winch Fairlead Mount.

Congratulations, you have installed your Poison

Spyder Customs BFH II front bumper!