Owners manual

POISON SPYDER CUSTOMS INST-17-16-021_A • JK BFH™ II Front Bumpers 2

If the Jeep is a 2007-2011 year model, it should not

require vacuum pump relocation, which is covered

in the following steps. Skip the next 10 steps and

continue at step 15.

4. If the Jeep is a 2012 or later model with the vacuum

pump located on the inner frame rail, it will need to be

relocated using the JK Vacuum Pump Relocation Bracket

(sold separately), Begin by removing the two bolts that

hold the vacuum pump into the mount on the Jeep’s frame.

5. Disconnect both hoses from the vacuum pump.

6. Disconnect the vacuum pump’s electrical wire

pigtail from the vehicle wiring harness by separating the

connector.

7. There are two rubber bushings in the mounting

ﬂanges on the vacuum pump, with steel sleeves inserted

into these bushings. Remove the steel sleeves, then re-

insert them into the rubber bushings from the opposite side

of the mounting ﬂange. This will move the ﬂat washer

surface of the steel sleeve to the other side of the rubber

bushing.