Owners manual

POISON SPYDER CUSTOMS INST-17-13-010_C • JK Body Mounted Tire Carrier 8

32. Repeat the previous procedures with the lower

hinge: hinge removal, grind and remove hinge pin, install

Lower Hinge Bracket, reinstall long side of hinge, install

Swing Stop Sleeve.

33. Install the four (4) Black Delrin Bushings into the tube

hinge sleeves on the Tire Carrier Main Structure. Use a

round ﬁle to make sure the ends of the tube sleeves are free

of burrs. Apply a thin ﬁlm of grease to the bushing, then

tap into place with a mallet.

34. Insert a 3/4” Inner Bushing Sleeve into the tire

carrier hinge bushings installed in the previous step. Before

inserting, de-burr and round over any sharp edges at the

ends of the sleeve with a ﬁle. Apply a thin ﬁlm of grease

to the sleeve, then tap it into place with a mallet. Do this

for both the upper and lower bushing/hinge assemblies

on the tire carrier.

35. With the help of a friend, lift and install the Tire Carrier

Main Structure into the Upper and Lower Hinge Brackets.

36. Locate the Upper Adjustment Cam. It is the one

that is NOT threaded, and is counter bored to accept the

head of a 1/2-13 X 4-1/2 Socket Head Cap Screw as

shown in the photo below.

Insert the 1/2-13 X 4-1/2 Socket Head Cap Screw,

through the Upper Adjustment Cam, into the Upper Hinge

Bracket and through the bushing sleeve.