Owners manual

INSTALLATION INSTRUCTIONS

FIGURE 5

7. Install the BodyArmor using two 1/4” at

head bolts. Make sure you place a small

amount of anti-seize on each bolt. Do not

over tighten the bolts; for this step you will

only need to snug them up.

8. Doublecheckthetmentto make sure you

are happy with it.

9. Usingthe 1/4” drill bit, drill the rest of the

mounting holes using the Body Armor as

your drill guide. Make sure you do not drill

through the inner panel.

FIGURE 6

10.RemovetheBodyArmorand set aside.

11.Use the 25/64th drill bit and open up the

holes you just drilled. Take your time drilling

these holes; the larger drill bit may catch and

distort the hole. Make sure you do not drill

through the inner panel.

12.Apply some touch up paint to the areas

where bare metal is exposed; this will aid in

the prevention of corrosion.

13.Usingthenutinserttool, install inserts into

the holes you just drilled. Do not over tighten

the nut inserts; this will cause them to distort

and not fasten to the body correctly.

14.Removethetapefromthe back of the Body

Armor.

15.(Optional) If you purchased the rubber

liners, they will need to be placed on the

back side of the Body Armor. Use a couple of

bolts to help hold the liner in place.

FIGURE 7

16.For the nal install it is helpful to have

someone assist you with lining things up.

See gure 14.

FIGURE 8

17.InstalltheBodyArmorusing 1/4” at head

bolts. Make sure you place a small amount

of anti-seize on each bolt. Make sure you get

each bolt started before you tighten any of

the bolts up. Do not over tighten the bolts; for

this step you will only need to snug them up.

Poison Spyder Customs • JK BODY ARMOR INSTALLATION Page 3