Owners manual

©2016 POISON SPYDER CUSTOMS 951-849-5911 • WWW.POISONSPYDER.COM
INSTALLATION INSTRUCTIONS INST-14-13-020_A
TJ Rear Stinger Tire
Carrier
IMPORTANT: Thank you for purchasing this Poison Spyder product. Please read through this entire document before proceeding with installation. If you are not
confident in your mechanical skills, please seek the help of a professional to perform the installation. Check your packages immediately upon arrival to ensure that
everything listed is included, and to check for damage during shipping. If anything is missing or damaged, or if you need technical assistance with any aspect of
this installation, call Poison Spyder at [phone] as soon as possible. This document last updated February 2016.
APPLICATIONS
These installation instructions apply to the following
Poison Spyder products:
14-13-020 TJ Rear Stinger Tire Carrier
PARTS LIST
Please check your packages immediately upon arrival
to ensure that everything listed is included, and to
check for damage during shipping. If anything is
missing or damaged, call Poison Spyder at (951) 849-
5911 as soon as possible.
(1) Rear Stinger Tire Carrier Main Assembly
(1) Lower Mount Plate
(1) Right Upper Corner Mount
(1) Left Upper Corner Mount
(1) 3-Way Spare Tire Strap
(8) Urethane bushing
(2) Thick wall bushing insert
(2) Thin wall bushing insert
(1) Rear Stinger Tire Carrier Hardware Kit
PN: HWKIT-14-13-020 includes:
(8) 3/8-16 X 3/4 SS Flat Head Cap Screw
(4) 3/8-16 X 1 SS Button Head Cap Screw
(12) 3/8-16 Gr8 Nylon Insert Lock Nut
(12) 3/8” SAE Hardened Flat Washer
(4) 5/8” SAE Hardened Flat Washer
(2) 5/8-18 X 4-1/2 Gr8 Hex Head Cap Screw
(2) 5/8-18 Gr8 Nylon Insert Lock Nut
(4) 1/4-20 X 3/4 SS Button Head Cap Screw
(4) 1/4” SAE Hardened Flat Washer
(4) 1/4-20 Gr8 Nylon Insert Lock Nut
(4) 7/16” SAE Hardened Flat Washer
(2) 7/16-14 X 1 Gr8 Hex Head Cap Screw
(2) 7/16-14 Gr8 Nylon Insert Lock Nut
(2) 1/2” X 4-3/4 Hitch Pin with Clip
TOOLS NEEDED
• Drill motor with 3/8” drill bit
• 7/32 hex key
• 9/16 wrench
• 13/16 wrench
• 7/8 wrench
BEFORE YOU BEGIN
The bare steel components of the Rear Stinger Tire
Carrier kit should be powder coated or painted prior
to installation. If powder coating, be sure to not install
the urethane bushings until AFTER the parts have
been powder coated, but make sure the coater masks
the inside of the bushing cavities as the thickness of
the powder coat may make installation of the bushings
difcult.
If painting the components, thoroughly wash and
prep the bare metal components, then apply a quality
metal-etching primer, followed by the paint color of
your choice.
Remove the existing tire carrier and rear bumper
prior to beginning this install. The removal procedure
of any existing rear bumper is not included in these
instructions. Retain the OE bolts that thread into the
bottom of the Jeep’s frame to hold the OE bumper on.
They will be re-used.
These instructions assume that Poison Spyder
Crusher Corners™ have already been installed.