Owners manual

POISON SPYDER CUSTOMS INST-14-66-010_A • TJ-YJ TrailGate™ 4

23. Upon closing the TrailGate, it is likely that the latch

will require some adjustment. Simple loosen/tighten the

jam nuts to move the latch in or out. Adjust the latch so

that the outer surface of the TrailGate™ is ﬂush with the

Jeep’s tub when closed and latched.

24. Use a grinder or pneumatic cut-off wheel to cut

off the excess threads from the end of the latch stud. It

will need to be shortened by about 1/4” for the latch to

function properly after the latch cover is installed.

25. Install the latch covers. Begin by removing the

u-brackets that were installed in a previous step, and

replace them with the latch covers using the M5-.8 X 50

hex head cap screws and #10 ﬂat washers provided. Note

that the latch covers are not identical, there is a right and

left cover. Make sure the rectangular notch for the latch is

oriented toward the bottom of the TrailGate™ (when gate

is closed).